How to Empty Bestway Steel Pro Max Pool
If you’re a proud owner of a Bestway Steel Pro Max pool, you might find yourself needing to empty it for various reasons. Whether it’s for maintenance, storage, or simply because you’re moving to a new location, knowing how to properly empty your pool is essential. In this article, we’ll guide you through the process of emptying your Bestway Steel Pro Max pool step by step.
Step 1: Prepare Your Pool
Before you begin the emptying process, it’s crucial to prepare your pool. Start by ensuring that the pool is completely deflated. This can be done by removing the air valve and allowing the air to escape. Once the pool is flat, you can proceed to the next step.
Step 2: Drain the Water
To drain the water from your Bestway Steel Pro Max pool, you’ll need a garden hose. Connect one end of the hose to the pool’s drain plug and the other end to a suitable drain outlet. Make sure the outlet is lower than the pool’s water level to allow for proper drainage. Once everything is connected, open the drain plug and let the water flow out. Keep in mind that it may take some time for the water to completely drain, depending on the size of your pool.
Step 3: Remove the Filter and Pump
After the water has drained, it’s time to remove the filter and pump. These components are usually located at the bottom of the pool. Carefully lift them out and set them aside in a safe place. Be sure to disconnect any electrical connections before removing them.
Step 4: Clean the Pool
Now that the water has been drained and the filter and pump have been removed, it’s a good opportunity to clean your pool. Use a pool brush to scrub the walls and floor of the pool, removing any dirt or algae. Rinse the pool thoroughly with clean water to ensure all debris is removed.
Step 5: Store the Pool
Once the pool is clean and dry, it’s time to store it. Begin by folding the pool’s walls and placing them inside the pool base. Secure the walls in place using the provided clips. Finally, cover the pool with a pool cover to protect it from the elements and prevent any dirt or debris from accumulating.
Step 6: Maintain Your Pool
While your Bestway Steel Pro Max pool is empty, it’s a great opportunity to perform regular maintenance tasks. Check the pool’s structure for any signs of damage, such as cracks or leaks. Inspect the filter and pump for any wear and tear, and replace them if necessary. This will ensure that your pool is in top condition when you’re ready to use it again.
In conclusion, emptying your Bestway Steel Pro Max pool is a straightforward process that requires careful preparation and attention to detail. By following these steps, you can ensure that your pool is properly drained, cleaned, and stored for future use. Happy swimming!
