How to Vacuum Pool with Hayward Sand Filter
Vacuuming your pool is an essential task to maintain its cleanliness and hygiene. If you have a Hayward sand filter, it’s important to know how to properly vacuum your pool to ensure the best performance of your filter system. In this article, we will guide you through the process of vacuuming your pool with a Hayward sand filter, step by step.
1. Prepare Your Equipment
Before you start vacuuming your pool, gather all the necessary equipment. You will need a pool vacuum, a telescopic pole, a pool brush, a pool skimmer, a garden hose, and a vacuum plate. Make sure that all your equipment is in good working condition.
2. Clean the Pool Skimmer
Inspect the pool skimmer and remove any debris or leaves that may be stuck in it. This will help prevent clogs and ensure that the skimmer works effectively during the vacuuming process.
3. Backwash the Hayward Sand Filter
If it has been a while since you last backwashed your Hayward sand filter, it’s a good idea to do so before vacuuming the pool. This will help remove any accumulated debris and ensure that the filter is working efficiently.
4. Adjust the Filter Setting
Set your Hayward sand filter to the “filter” position. This will allow the filter to pump water through the sand bed and effectively remove impurities from the pool water.
5. Prime the Vacuum System
Attach the vacuum plate to the skimmer and submerge the vacuum head in the pool. Connect the garden hose to the vacuum head and run it to the nearest drain or a bucket. Turn on the water supply to prime the vacuum system.
6. Attach the Telescopic Pole and Brush
Attach the pool brush to the telescopic pole and submerge it in the pool. This will help to remove any dirt or algae that may be stuck to the pool walls or floor.
7. Start Vacuuming
Begin vacuuming the pool by moving the vacuum head in a systematic pattern. Start from one end of the pool and move in a straight line towards the other end. Pay special attention to areas with high levels of debris or algae.
8. Clean the Filter
After vacuuming the entire pool, clean the Hayward sand filter by backwashing it. This will help remove any remaining debris from the sand bed and maintain the filter’s efficiency.
9. Clean the Vacuum Head and Pole
Once you have finished vacuuming the pool, clean the vacuum head and telescopic pole. This will help prevent any debris from sticking to them and ensure that they are ready for the next use.
By following these steps, you can effectively vacuum your pool using a Hayward sand filter. Regular vacuuming will not only keep your pool clean but also help extend the life of your filter system. Remember to perform this task regularly to maintain the overall health of your pool.
